Accessories & Parts
| Item | Part Nbr | Description | Pkg Qty |
|---|---|---|---|
| INTAKE FILTER | 081 | Protects fogger motor and extends service life. (Intake of dust, dirt and fog droplets reduces motor brush life and increases the potential for internal corrosion.) For hand-held and drum mount units. | 1 |
| 080 | 10 | ||
| MOTOR BRUSH | 030 | Conventional design. Graphite brushes (2 per motor) carry electricity to commutator. Brush is a non-warranty wear item (650 hours estimated service life). 120/240V. | 2 |
| 033 | Motor Saver style. Cuts off current to motor at the end of brush life (about 650 hours) to prevent arcing and damage to commutator. Included with Sentinel II and DM units. Recommended for extensive fogging applications requiring regular brush changes. Interchangeable with conventional graphite brush (motor saver brush may be installed in one slot and regular brush in the other). 120/240V | 2 | |
| PUMP | 6300 | PUMP-R low pressure boost pump for applications where nozzle is more than 6 feet above supply liquid level (suction lift of aspirating nozzle is 6 ft). 38 psi [2.6 bar], 40 oz/min [70 LPH]. (120VAC: p/n 630010; 240VAC: p/n=630020). | 1 |
| TANK LINER | 900 | Polyethylene liner for tank of hand-held foggers simplifies chemical changes and clean-up after use. Also protects tank from contact with corrosive chemicals. | 10 |
| 901 | 50 | ||
| TIMER | 7304 | Countdown timer shuts off fogger. Time set with manual dial (60 minute maximum). Useful for fogging at end of workday when facility is empty. Can be used with 6100 turntable. 10 A contacts. | 1 |
| 2238 | Repeat cycle timer. For odor control or applications requiring periodic discharge. Independent ON and OFF cycles (1-100 minutes each) let you balance fogging time/chemical usage. Cycle length set with one-turn analog dial. 10 A contacts. (120VAC: p/n 223810; 240VAC: p/n=223820). | 1 | |
| 2239 | Event timer. The 2239 timer offers two timing functions: a programmable seven-day clock; and a repeating cycle timer. They can be used separately, or jointly. The 7 day clock holds up to 6 events, each with its own start and stop times. Starts and stops can be set for a specific day of the week, or for every weekday (Mon-Fri), or every weekend day (Sat-Sun). When an event starts, the clock delegates control to the repeating cycle module. This turns the fogger on and off repeatedly until the event ends. "On" and "off" cycle lengths are set using two banks of dip switches (1-165 minutes in one-minute increments). A toggle switch allows you to override cyclic operation if continuous output is desired. 10 A contacts. (120V: p/n 223910; 240V: p/n 223920) |
1 | |
| TURN TABLE | 610010 | Assures uniform distribution when fogging large areas with hand-held unit (Tri-Jet, Pow-R-Jet and Micro-Jet units only; not compatible with DM models). 2-3 rpm. 120VAC. | 1 |
| Home | Products | Applications | Technical and Company Info |
FAQ | Response Form |